 Note:
After this procedure is started and a button is not
pressed within 20 seconds, the remote will end the
procedure automatically.
Simply start over again.
- Verify the remote is a DISH Network
remote.
Look for the DISH Network logo at the bottom of
the remote.
We have the codes for all DISH Network
remotes and would be happy to help you with
your DISH Network manufactured remote.
Please contact the manufacturer of your
remote for further assistance. Detailed
instructions may be included in the owners'
manual that came with your equipment. If
not, there may be a toll-free technical
support number listed.
- With the desired equipment ON, press
and hold the correct Mode button until
all mode button backlights illuminate (about 3
seconds), then release.
Note:For AUX mode Power Scan ONLY:
press 0 for a TV, press 1 for a VCR/DVD, press 2
for any other device, then press *.
- Press and release the Power button.
- Press the Up button once a second
while pointing the remote at the desired
equipment.
If the code for the equipment comes up, the
equipment will power off.
- Press the POUND (#) button.
If the code entered is valid for the remote,
the mode light flashes three times.
- To verify that the code works try several
different functions for that equipment.
Power Scan Tips:
- When performing the Power Scan,
periodically check that the mode light is
not lit when the channel up/down button is
pressed. This will ensure you are doing the
Power Scan correctly.
- The Power Scan will start with the last
code you put in. If the last code you put in
was 656 it will then go to 657 when pressing
the Up button when performing a Power Scan.
- If there is no code programmed into the
remote at the time of the Power Scan then it
will start with 000 regardless of the type
of remote.
- Whether the scan then proceeds ascending
or descending from this number depends on
whether you scan with the Up or Down buttons
on the remote. For consistency, and to most
rapidly go through the most common codes
more quickly, you should use the up button
exclusively, unless you pass a functional
code by accident and wish to toggle back
down to it.
- Manually turn on the device you are
scanning for before you begin the Power
Scan.
- If the scan powers the device off, but
does not give full function re-enter scan
mode and continue (example: there are
multiple RCA TV codes).
- Remember not all devices are supported,
and many will only give you basic functions.
- If performing the Power Scan correctly
then it should not take more than six
minutes. On average you should find the
correct code within two minutes.
- The Mode button will flash rapidly when
you reach the end of the codes.
If you are performing a Power Scan in AUX mode,
the steps you should follow are below:
- Hold down the AUX button so all buttons
light up
- Enter in prefix 0 = TV, 1 = VCR, 2 = AUX
device
- Press the asterisk button "*"
- Power then press the Up/Down like you
would with a regular power scan.
|
All Rights
Reserved - Copyright ©
Omnivision Satellite Systems, Sonora, CA 95370.
1999-2007