Click -Here- to Save to Favotites

 Click -Here- to Print this Guide
 
Remote Control Programming Instructions
Please note: you must add the number "2" before the 3 digit code when programming the AUX button for a Stereo or A/V receiver
  1. Verify the remote is a DISH Network remote. Look for the DISH Network logo on the bottom of the remote and Mode buttons or lights at the top.
  2. Look up the Code(s) for the piece of equipment you are trying to address.  You can look up Here
  3. Press and hold the correct Mode button (about six seconds) until all mode key backlights come on, then release.
  4. Use the number pad buttons to enter the three digit number (four digit for AUX mode) corresponding to the equipment. The light will blink off after each digit is entered and then return to a steady light.
  5. Press the POUND (#) button. If the code entered is valid for the remote, the mode light flashes three times.
  6. To verify the code works, press the mode button. Then try several different functions for that equipment. Some codes may provide partial function, or respond differently than the button's titled function. Try the other codes listed for that device until you find one that offers more complete functionality.
  7. Store the remote code for future use.
  8. If the remote still does not operate the device, perform the Power Scan.  If still no operation, it may not be compatible with that piece of equipment.   
Click -Here- to Close Window

All Rights Reserved - Copyright © Omnivision Satellite Systems, Sonora, CA 95370. 1999-2007