Instructions for Changing the Remote Control Address

The only reason to do this procedure is if ONE remote is controlling TWO Dish Network receivers!

1. Verify the remote is a DISH Network remote. Look for the DISH Network logo on the bottom of the remote and Mode buttons or lights at the top.
2. With the receiver on, press the Info or System Info button on the front panel, if not present remove the Smart Card and wait 5-10 sec, if no Smart Card power the receiver off from the front panel and press the UP or DOWN arrow button. System info will appear on screen.
3. Press and hold the SAT button (about six seconds) until all mode key backlights come on, then release.
4. Use the number pad buttons to enter a number from 1 to 15. The light will blink off after each digit is entered and then return to a steady light.
5. Press the POUND (#) button. If the code entered is valid for the remote, the SAT mode light flashes three times.
6. Press the Record button. The number in the Remote Address field should match the one you input.
7. To verify the code, press and hold the SAT mode button until the mode lights come on. Then press the POUND (#) button twice. The light will flash the address.